PART NUMBER SEARCH


Curtis



Our Part Number: G632D
Name: Speed Controller 36V 300amp
List Price: $420.00
Price: $269.00
Core Charge: 100.00
In Stock: Ships in 1-3 Days
Repair Price: $239.00
 
Interchange Part Numbers
1206
1206 36V 275A DCS
1206 SX DCS
Curtis1206 DCS
Curtis1206 SX 005
Curtis73144G01
Curtis73144G01RB
Curtis73144G02
Curtis73144G03
Curtis73144G04
Curtis73144G05
Curtis73144G06
Curtis73144G07
Curtis73144Gxx
CurtisCP73144-G01
CurtisG632D
  1206 SX for DCS Cars
9 pin controller
Electronic Speed Controller is used on 1994-2000 E-Z-GO Electric with DCS (Drive Control System). Note: There are 3 large terminals (A1, B-, A2/B+), 2 smaller ones (F1, F2) and the 9-pin connector


G632P -1206 MX PDS External Wiring
EzGo PDS controller test.pdf
PD140224-395.jpg
Our Part Number: G632P
Name: Speed Controller 36V 275amp
List Price: $364.18
Price: $229.00
Core Charge: 100.00
In Stock: Ships in 1-3 Days
Repair Price: $229.00
 
Interchange Part Numbers
1206
1206 36V 275A PDS
1206-MX4301
1206 MX 4301
1206 MX PDS
1206 PDS
73263G01
73263 G01
73326G07
SCP EZ 73326G06 BU
Curtis1206 MX
Curtis1206 MX 1115
Curtis1206MX-1120
Curtis1206 MX 1121
Curtis1206MX-4301
Curtis609083
Curtis6-230P
Curtis73326G02
Curtis73326G03
Curtis73326G04
Curtis73326G05
Curtis73326G06
CurtisCON-347
CurtisG632P
  PDS Shunt Controller ITS Throttle Input. Electronic Speed Controller (PDS/VPS) is used on 1994-current E-Z-GO Medalist & TXT Models with the PDS (Precision Drive System) and/or VPS (Vehicle Performance System) applications for Golf Cars and Vehicles to enhance power and speed while maintaining the E-Z-GO Safety Standards for each vehicle. The speed controller is responsible for regulating the speed levels and performance of your vehicle. There are three large terminals on the end of the controller (A1, B- and B+) and two smaller terminals on the opposite end (F1, F2).
CHECK MOTOR WINDINGS:
1- Set your VOM to RESISTANCE (O).
2- With your motor disconnected, measure A1 to A2. This must measure BETWEEN .3O and 1O.
3- With your motor disconnected, measure F1 to F2. This must measure BETWEEN 1O and 2O.
4- With your motor disconnected, measure A1 to F1. This must measure OPEN.
5- With your motor disconnected, measure F1 to the motor case. This must measure greater than 5MO.
CHECK the MAIN SOLENOID:
1- Disconnect all wires from the main solenoid.
2- Set your VOM to RESISTANCE (O).
3- Measure the solenoid coil. This must measure NO LESS than 100O.
4- Connect VOM leads to the main solenoid lugs.
5- Attach jumpers from the main battery positive and negative to the coil (small terminals).
1- The meter must jump from infinity to LESS THAN .3O.
2-Remove jumpers and reconnect solenoid wiring from the harness. (If suppression diode is present,
The non-banded side must go the blue wire – pin J1-6 from the controller.)
This cart is capable of diagnostics! Placing the cart in the
diagnostics mode will allow the controller to use the back-up
alarm to beep out codes. Do not underestimate the usefulness of this tool. There is an orange and white sticker on the
environmental cover that explains how to enter the diagnostics
mode


G632 - External Wiring.pdf
Installation help 3 or 4 blades
Our Part Number: G633
Name: Speed Controller 36V 350amp
List Price: $415.29
Special Price: $229.00
Core Charge: 60.00
In Stock: Ships in 1-3 Days
Repair Price: $239.00
Special Repair: $229.00
 
Interchange Part Numbers
1206
1206 36V 350A UPG
1206-4301
1206 TXT 5Pin UPGR
25864G03 Upgraded
25864G04 Upgraded
25864G05 Upgraded
25864G06 Upgraded
25864G07 Upgraded
25864G08 Upgraded
25864G09 Upgraded
25864G10 Upgraded
Curtis1206 TXT
Curtis25864G03
Curtis25864G05
Curtis25864G06
Curtis25864G09
Curtis25864G0x Upgraded
CurtisCP28349 G01RB
GolfRamaG633
  When it's time to replace the Controller, you should also check the Motor since extreme conditions such as lightning can cause both the Controller and Motor permanent damage.
1206 Upgraded 350Amp, 5-pin controller
Controllers are the most vulnerable to damage from lightning
This Electronic Speed Controller is used on 1994-current E-Z-GO Medalist and TXT 36-Volt Series Electric Vehicles. The speed controller is responsible for regulating the speed levels of your vehicle.This particular speed controller is not designedfor use with DCS (Drive Control System) or PDS (Precision Drive System) vehicle applications
     |     Total: 24     |      Page 7 of 8     |      | | |