E-Z-GO Speed Controller 36V 275amp
PDS Shunt Controller ITS Throttle Input

OE Part Number

1206 MX PDS, 1206MXPDS

ProgRama Part Number


Interchange Part Numbers

1206, 1206
1206 36V 275A PDS, 120636V275APDS
1206 MX, 1206MX
1206 MX 1115, 1206MX1115
1206 MX 1121, 1206MX1121
1206 MX 4301, 1206MX4301
1206 PDS, 1206PDS
1206-MX4301, 1206MX4301
1206MX-1120, 1206MX1120
1206MX-4301, 1206MX4301
6-230P, 6230P
609083, 609083
73263 G01, 73263G01
73263G01, 73263G01
73326G02, 73326G02
73326G03, 73326G03
73326G04, 73326G04
73326G05, 73326G05
73326G06, 73326G06
73326G07, 73326G07
CON-347, CON347
SCP EZ 73326G06 BU, SCPEZ73326G06BU




90 Days

Item description

Upgrades to 350Amp G633P PDS Shunt Controller ITS Throttle Input. Electronic Speed Controller (PDS/VPS) is used on 1994-current E-Z-GO Medalist & TXT Models with the PDS (Precision Drive System) and/or VPS (Vehicle Performance System) applications for Golf Cars and Vehicles to enhance power and speed while maintaining the E-Z-GO Safety Standards for each vehicle. The speed controller is responsible for regulating the speed levels and performance of your vehicle. There are three large terminals on the end of the controller (A1, B- and B+) and two smaller terminals on the opposite end (F1, F2). CHECK MOTOR WINDINGS: 1- Set your VOM to RESISTANCE (O). 2- With your motor disconnected, measure A1 to A2. This must measure BETWEEN .3O and 1O. 3- With your motor disconnected, measure F1 to F2. This must measure BETWEEN 1O and 2O. 4- With your motor disconnected, measure A1 to F1. This must measure OPEN. 5- With your motor disconnected, measure F1 to the motor case. This must measure greater than 5MO. CHECK the MAIN SOLENOID: 1- Disconnect all wires from the main solenoid. 2- Set your VOM to RESISTANCE (O). 3- Measure the solenoid coil. This must measure NO LESS than 100O. 4- Connect VOM leads to the main solenoid lugs. 5- Attach jumpers from the main battery positive and negative to the coil (small terminals). 1- The meter must jump from infinity to LESS THAN .3O. 2-Remove jumpers and reconnect solenoid wiring from the harness. (If suppression diode is present, The non-banded side must go the blue wire – pin J1-6 from the controller.) This cart is capable of diagnostics! Placing the cart in the diagnostics mode will allow the controller to use the back-up alarm to beep out codes. Do not underestimate the usefulness of this tool. There is an orange and white sticker on the environmental cover that explains how to enter the diagnostics mode

Item Weight

5.00 lbs

Shipping Weight

13.00 lbs

List Price



(Core Charge 60.00)

Repair Price


We'll buy your Core


Compatible Cars

Make Model Year
E-Z-Go Medalist 1993, 1994, 1995, 1996, 1997, 1998, 1999
E-Z-Go TXT 1996, 1997, 1998, 1999, 2000, 2001